Difference between revisions of "Using Medusa"
From Medusa
(Created page with "== Buttons == There are three buttons "left", "middle" and "right". * Standard functions ** "left" - "up" ** "middle" - "down" ** "right" - "enter" * Special functions (when both RGB and SDTV signals are detected - LED is yellow) ** "middle" - switch between RGB and SDTV input. * Special functions (after power on) ** "right" alone - enter "firmware updater" - usually you do not need to do that manually - firmware updating application does this automatically for you *...") |
|||
| Line 16: | Line 16: | ||
== Info on OLED == | == Info on OLED == | ||
[[File:osd_info.png|400px|thumb]] | |||
Lines: | Lines: | ||
| Line 25: | Line 27: | ||
# - Current DVI window (you may think of it as a "resolution") | # - Current DVI window (you may think of it as a "resolution") | ||
# - Screen shift horizontal:vertical | # - Screen shift horizontal:vertical | ||
# - Working Pixel Frequency | # - Working Pixel Frequency | ||
== Front LED color == | == Front LED color == | ||
Revision as of 17:47, 22 June 2022
Buttons
There are three buttons "left", "middle" and "right".
- Standard functions
- "left" - "up"
- "middle" - "down"
- "right" - "enter"
- Special functions (when both RGB and SDTV signals are detected - LED is yellow)
- "middle" - switch between RGB and SDTV input.
- Special functions (after power on)
- "right" alone - enter "firmware updater" - usually you do not need to do that manually - firmware updating application does this automatically for you
- "left" and "middle" together - factory reset (blue LED should be on for couple of seconds)
Info on OLED
Lines:
- - used A/D chip (RGB or SDTV) and input (SCART/VGA for RGB and S-VIDEO/CVBS for SDTV) or firmware version when there is no input signal
- - detected mode, for RGB name of the system ("Atari ST PAL", "Amiga PAL" itp.), for SDTV detected signal standard (PAL, NTSC, SECAM with type) or "NO INPUT SIGNAL"
- - Horizontal frequency of input signal
- - Vertival frequency of input (and output) signal
- - Flags (such as LINEDBL - line doubling)
- - Current DVI window (you may think of it as a "resolution")
- - Screen shift horizontal:vertical
- - Working Pixel Frequency
Front LED color
- Red - RGB signal detected
- Green - SDTV signal detected
- Yellow - both signals detected (RGB on VGA and SDTV on SCART) - in this mode you may switch input using "middle" button
- Blue - firmware flash / clearing settings
- Nothing - no input signal detected
